Buying Guide
Flush Door Sizes and Thickness: How to Choose and Measure
By Lucky Trading Company · Updated November 2026
A flush door that does not fit the frame is an expensive mistake. Sizes vary between brands, old houses rarely match modern standards, and a door cannot be made bigger once it is bought. This guide covers the sizes and thicknesses you will commonly meet and the measuring steps that prevent a wrong order.
Common Sizes
Flush doors are usually sold in a set of standard heights and widths, and many dealers can also supply other sizes on request. The figures below are the ones most often asked for in homes. Treat them as typical, and confirm what is available before you plan.
| Door | Typical width | Typical height |
|---|---|---|
| Main entrance | About 900 mm to 1000 mm (3 ft to 3 ft 3 in) | About 2000 mm to 2100 mm (6 ft 8 in to 7 ft) |
| Bedroom | About 800 mm to 900 mm (2 ft 8 in to 3 ft) | About 2000 mm to 2100 mm |
| Bathroom or utility | About 600 mm to 750 mm (2 ft to 2 ft 6 in) | About 2000 mm to 2100 mm |
Common Thicknesses
Flush door shutters are commonly made in thicknesses such as 30 mm, 35 mm and 40 mm. A thicker shutter feels more solid, holds hinges and locks better and gives a little more sound reduction. The thinner ones are fine for interior doors that are not heavily used.
- Interior doors such as bedrooms and storage often use the thinner shutters.
- Main entrances usually justify the thicker shutters, because they carry heavier locks and see more use.
- Bathrooms need a moisture-resistant door, and the grade matters more than the thickness.
How to Measure Your Frame
- Measure the clear opening of the frame (chaukhat), not the wall opening. Measure the inside width at the top, middle and bottom, and the inside height at the left, middle and right.
- Use the smallest of each set of measurements. Frames are rarely perfectly square.
- Leave a small gap. A door needs a few millimetres of clearance on the sides and top so that it opens freely and has room to swell in humid weather. Check the exact figure with your carpenter, because it depends on the finish and the hinge type.
- Allow for the floor. If you plan thick tiles or a carpet, measure the height from the finished floor level, not the bare floor.
- Write the size in one unit. Mixing feet, inches and millimetres is a common source of order errors.
If Your Frame Is Not Standard
Older houses and custom joinery often have odd sizes. In that case you can ask your carpenter to trim a slightly oversized door to fit, or order a custom size if the dealer offers it. Trimming works only within limits, so do not rely on cutting more than a few millimetres from the edges, which can expose the core.
Match the Door to the Room
Once you have the size, the next choice is the type of door and its core. Our guide to buying flush doors explains the main types and what to check, and the new home flush door guide helps you plan the whole house.
Send us the size you need on WhatsApp and we will tell you what we have in stock.
Frequently Asked Questions
What is the standard flush door size?
There is no single size, but interior doors are commonly about 2000 to 2100 mm high, with widths from roughly 600 mm for bathrooms to 900 mm or more for main entrances. Confirm availability before ordering.
Which flush door thickness should I choose?
Shutters are commonly 30, 35 or 40 mm. Thicker shutters feel more solid and suit main entrances, while thinner ones are usually fine for interior doors.
How do I measure for a flush door?
Measure the clear opening of the frame at several points, use the smallest figure, and leave a few millimetres of clearance. Measure height from the finished floor level.
Ready to buy?
Message Lucky Trading Company on WhatsApp for wholesale rates and honest advice on what to buy.
Ask on WhatsApp